User Manual

4. ATTACHING CASTERS

11.11.

11.Put caps #15 into ends of caster

beams #12 (see Detail

H).

12.12.

12.Attach one

non-lockingnon-locking

non-locking caster

#13 and one

lockinglocking

locking caster #14 to

each caster beam #12 with

locknuts #17. (See Detail

H).

TIGHTEN CASTERS BUT DOTIGHTEN CASTERS BUT DO

TIGHTEN CASTERS BUT DO

NOT OVERTIGHTENNOT OVERTIGHTEN

NOT OVERTIGHTEN

CRUSHING TUBES.CRUSHING TUBES.

CRUSHING TUBES.

13.13.

13.Attach caster beams to upright

assemblies #11 with bolts #25,

washers #23, and spacer bushings

#19.

NOTE:NOTE:

NOTE: Spacers bushings #19

slide

INSIDEINSIDE

INSIDE

caster beams #12 to

keep beams from crushing. (See

Detail

J). Tighten bolts #25 tight.

14.14.

14.Lock both locking casters #14.

(See Below).

NOTE: Casters should alwaysNOTE: Casters should always

NOTE: Casters should always

be locked unless moving table.be locked unless moving table.

be locked unless moving table.