2L-6670-01
1. ATTACHING LEGS TO TABLE TOPS CAUTION AT LEAST TWO ADULTS ARE NEEDED TO COMPLETE THE FOLLOWING STEPS! 1. Leave top halves #1 in shipping carton as shown 3. Put caps #21 on bottom end of leg assembly above or lay them on a carpeted floor (to protect #10. (See Detail C). them from damage and scratches ). 4. Attach upright assembly #11 to remaining 2. Attach leg assembly #10 to brackets #6 located brackets #6 on the bottom of the first top half #1. on the bottom of the first top half #1. (See above).
2. ATTACHING NAME PANELS TO LEGS CAUTION AT LEAST TWO ADULTS ARE NEEDED TO COMPLETE THE FOLLOWING STEPS! DO NOT LEAVE TABLE UNATTENDED UNTIL ASSEMBLY IS COMPLETE! 6. With a helper helper,, hold top halves about 15 ½ inches apart. Attach only one half of name panels #8 to upright assemblies #11 as shown above. Use ONLY TWO bolts #25 and locknuts #29 on each name panel.
4. ATTACHING CASTERS 11. Put caps #15 into ends of caster beams #12 (see Detail H). 12. Attach one non-locking caster #13 and one locking caster #14 to each caster beam #12 with locknuts #17. (See Detail H). TIGHTEN CASTERS BUT DO NOT OVERTIGHTEN CRUSHING TUBES. 13. Attach caster beams to upright assemblies #11 with bolts #25, washers #23, and spacer bushings #19. NOTE: Spacers bushings #19 slide INSIDE caster beams #12 to keep beams from crushing. (See Detail J). Tighten bolts #25 tight. 14.
5. SETTING TABLE UPRIGHT CAUTION At least two adults are needed to complete the following steps. Be sure top halves are locked in safety latches! Be sure that both locking casters are locked! You must use a 7" stack of magazines (or similar block) to protect the casters when lifting table upright! 15. Before lifting table, be sure both top halves are locked in safety latches! Be sure casters are locked! Put a 7 inch stack of magazines, wood, etc. under caster beam nearest the floor to protect casters.
FINISHING THE ASSEMBLY NOTE: If sides of table are not even with one another, loosen the bottom four bolts that were loosened in step #18 and push both sides inward as shown until they are even. Retighten bolts when sides are even.
Ó 2013 Escalade ÒSports
