Operation Manual
7
WARNING!
cap firmly.
WARNING! Immediately clean all traces
of fuel which may have dripped on the ma-
chine or the ground and do not start the en-
gine until the petrol fumes have dissipated.
3. USING THE MACHINE
3.1 STARTING THE MACHINE
WARNING! The machine must be started
in an area at least 3 metres from where you
Before starting the engine:
3.1.1 Cold starting
WARNING! A “cold” start of the engine
means starting it after at least 5 minutes from
when it was switched off or after refuelling.
1.
IMPORTANT To prevent distortions, the drive
tube must not be used as a support for the hand
or knee during startup.
-
IMPORTANT To avoid breaking the starter ca-
ble, do not pull the whole length of it or let it slide
along the edge of the cable guide hole. Release
7. Pull the starter grip again until the engine
WARNING! Starting the engine with the
-
connected.
-
sition.
-
IMPORTANT If the starter grip is pulled repeated-
make starting difficult.
-
trodes and replace it on the engine.
3.1.2 Warm starting
-
above in points 1-5-6-7.
3.2 ADJUSTING THE SPEED
WARNING! The cutting device must not
move when the engine is running idle. If the
cutting device moves when the engine is
running idle, contact your dealer to correctly
regulate the engine.
IMPORTANT Avoid using the engine at full pow-
er for the first 6-8 working hours.