Operation Manual
6
EN
6. OPERATION
THE SWITCH TRIGGER, and remove the debris.
keep line long enough to advance properly.
WARNING
When servicing, use only identical replacement parts.
Use of any other parts may create a hazard or cause
product damage.
WARNING
performing any maintenance.
GENERAL MAINTENANCE
Before each use, inspect the entire product for
bolts, caps, etc. Tighten securely all fasteners and caps
and do not operate this product until all missing or
damaged parts are replaced.
plastics are susceptible to damage from various types
of commercial solvents and may be damaged by their
use. Use clean clothes to remove dirt, dust, oil, grease,
etc.
WARNING
Do not at any time let brake fluids, gasoline,
petroleum-based products, penetrating oils, etc.,
in serious personal injury.
L
be repaired or replaced by the customer. All other parts
should be replaced at an Authorised Service Centre.
WARNING
performing any maintenance.
WARNING
can result in serious personal injury.
CUTTING TIPS
See Figure 6.
the best cutting area.
to right across the area to be cut; it is less effective
Use the tip of the cutting line to do the cutting; do not
force cutting head into uncut grass.
siding, and fence posts can easily be damaged by
the cutting line.
Attach metal knob to the rubber hole on the rear
in use.
ADVANCING CUTTING LINE
the head to try to advance the line.
line reaches the length of the grass deflector cut-off
blade.
Resume trimming
ADVANCING THE CUTTING LINE MANUALLY
Remove the battery pack.
Push the black button located on the cutting head
cutting line.
machine to its normal operating position before
LINE CUT-OFF BLADE See Figure 6.
the grass deflector. For best cutting, advance line
until it is trimmed to length by the line cut-off blade.
OPERATION