JB 55 EN PL CS OPERATOR´S MANUAL ,16758.
EN ENGLISH 2.2 PREPARATIONS 1 SYMBOLS, SEE FIG. 1 The following symbols can be found on the tiller. Their purpose it to remind you of the care and attention required when using it. If any symbol is missing, damaged or unreadable, it should be immediately replaced with a new one. The symbols mean: 1. Warning! Read the instructions. 2. Warning for rotating blades. 3. Reverse gear. 4. Clutch handle. Handle out, left fig. = disengaged. Handle pressed in, right fig. = engaged. 5.
EN ENGLISH • Always keep at a safe distance to the rotors when working. • Holding the steering correctly ensures a safe distance. • No person must come closer than 20 m to the machine when working on slopes. The user must hold the steering firmly with both hands all the time. • • 1. Clutch control, activation of the blades 2. Gear control, forward/reverse Never touch the engine when operating the machine, or just afterwards. Risk for burn injuries. 4.
EN ENGLISH 5.3 SUPPORT WHEEL, SEE FIG. 5 6.3 FORWARD OPERATION, SEE FIG. 2. Fit the support wheel according to the figure. Do not tighten the nut (5) too hard. It will not be possible to fold the wheel arm up. Forward gear is selected when the left handle, the gear control (2), is not pushed in. The tiller starts forward when the clutch handle (1) is pulled in. Go forwards as follows: 5.4 FILLING THE OIL, SEE FIG. 2 1. Set the throttle control (10) in the required position.
EN ENGLISH 8.5 CLEANING 8 MAINTENANCE WARNING! Repairs must be carried out by the dealer. Otherwise the warranty is not valid. WARNING! The spark plug lead should be disconnected before carrying out repairs or maintenance. See section 2.4. First brush off all the loose dirt. Then wipe the tiller with a damp cloth. The frame can be flushed clean with water. 8.6 REPLACEMENT OF DRIVE BELT, SEE FIG 13 1. Remove the cover (16) in fig. 2. 8.1 PERIODIC MAINTENANCE 2.
EN ENGLISH 8.9.4 Fault: Slips when moving forward. Reason: The belt is too slack. Procedure: Adjust the belt. 10 CE CERTIFICATE Reason: Run out of fuel. Ets PUBERT SA Z.I. de Pierre-Brune, 85110 CHANTONNAY, France warrants that tiller JB 55 complies with the essential health and safety requirements in the directives 89/ 392 CEE and 98/37/CE.
1 2 3 4 6 5a 5b 5c Fig. 1 10 1 11 1 2 10 6 2 2 3 11 4 12 12 5 13 13 3 16 6 6 7 7 19 8 9 15 9 14 15 Fig. 2 Fig. 3. Fig. 4.
Fig. 5. Fig. 8. 4 1 2 RUN CHOKE 3 Fig. 9. Fig. 6. Fig. 7. Fig. 10. RUN Fig. 11a. Fig. 11b. CHOKE Fig. 11c.
A 1 Fig. 12. +1 cm Fig. 15. A C Fig. 13. Fig. 16. 5 mm A Fig. 14. Fig. 17.
