STIGA COMPACT LINE SNOW REX SNOW BREEZE BRUKSANVISNING SV .... 6 KÄYTTÖOHJEET FI ...11 BRUGSANVISNING DA ..17 BRUKSANVISNING NO .22 GEBRAUCHSANWEISUNG DE ...28 INSTRUCTIONS FOR USE EN...34 MODE D’EMPLOI FR....39 ISTRUZIONI PER L´USO IT.....46 INSTRUKCJA OBS£UGI PL ....52 »HC“P”K÷»fl œOÀ‹«Œ¬¿“EÀfl RU...58 NÁVOD K POU®ITÍ CS ...65 HASZNÁLATI UTASÍTÁS HU ..71 NAVODILA ZA UPORABO SL ....
1 A T E B A U 3 I L H 4 BREEZE M H L E U 5 6 BREEZE R O H Q 2 N BREEZE V
8 7 REX H M L E 9 REX 10 REX O R N 11 12 3
EN ENGLISH 1 SYMBOLS The following symbols appear on the machine. They are there to remind you of the care and attention required in use. This is what the symbols mean: Warning. • • Read and understand the owner’s manual before using this machine. Danger - rotating auger. Danger - rotating fan. Keep hands out of discharge chute. Keep hands and feet away from rotating parts. Keep bystanders at a safe distance from the machine. Never point the discharge chute towards bystanders.
EN ENGLISH • • • • • • Disengage the auger when the snow thrower is to be transported or is not in use Do not drive too fast on slippery surfaces when transporting. Only use accessories that are approved by the machine’s manufacturer. Never drive the snow thrower in bad visibility or without satisfactory lighting. Always ensure you have a good balance and a tight grip on the handle. Never use the snow thrower on a roof. Do not touch engine components because they are warm during use.
EN ENGLISH Do not start the engine until filled with oil. The engine can be seriously damaged without oil. 1. Place the machine on a level floor. 2. Undo the oil filler cap (5, 9:U) and pull up the dipstick. Read off the oil level from the dipstick. Fill up the oil up to the “FULL” mark. See fig. 8. 3. Use oil according to the table below: Use Oil Grade Över -18° C SAE 5W-30 Minst SH Under -18° C SAE 0W-30 Minst SH Do not use SAE 10W40. 4. Always check the oil level in the engine before use.
EN ENGLISH 5.6 Starting Never aim the snow at bystanders. Always stop the engine before unclogging. Always wear eye protection when operating the snow thrower. 5. Remove the spark plug cable from the spark plug. 6. Clean the snow thrower after each use. Wash off with water to remove salt or other chemicals. Wipe the snow thrower dry 6 MAINTENANCE Before carrying out maintenance work, disconnect the cable from the spark plug. 1. Start the engine as above. 2. Set the height of the deflector (5, 9:L).
EN ENGLISH 4. Start the snow thrower and check operation. The auger should rotate when the auger drive lever is activated and remain stationary when the auger drive lever is released. If this is not the case, repeat the above procedure. 8.2 Belt cover (BREEZE) 1. Dismantle the belt cover (13:C) by removing the ten screws (13:D). Five screws on the outside, three screws on the underside and two screws on the upper side. 2. Reassemble in reverse order. Attention! One screw is shorter than the others.
w w w. s t i g a .
