Operation Manual

36
User’s manual
EN
WORK SCHEDULE 1: Function for setting the  rst time
of the robot’s working day. The cursor automatically
positions itself in the area under the  rst time (e.g.
10:00am to 1:00pm). Set the time for the start and end
of the work. Setting the time at “00:00 – 00:00” means
that the robot will not work during the  rst working time.
If the robot emits a beep and resets the time when this is
entered, it means there is an inconsistency with the time
entered or with the second working time.
WORK SCHEDULE 2: Function for setting the second
time of the robot’s working day.
WORK SCHEDULE 1
00 : 00 : 00 : 00
01
02
03
07
If it is necessary to set secondary areas, then it is preferable
to program both working times in order to increase the
mowing frequency of the area.
Approximately 4.0 hours is needed to fully charge the
battery. Therefore, it is recommended to leave an interval
of 4 hours between working time 1 and working time 2.
The setting of the time is essential for the robot’s proper functioning. Many parameters
in uence the setting of the working time, such as the secondary areas, number of batteries,
complexity of the lawn, type of grass, etc. Generally, the working hours must be increased
slightly when mowing gardens with secondary areas, with lots of obstacles and complicated
areas. Below is a table with the indicative times for con guring the robot on  rst use.
NB. Set all the weekdays at “1” – “Work Days.”
M² (sq ft) Time 1 Time 2
0400
(4304) 10:00 - 11:30
0800
(8608) 10:00 - 13:00
1200 (12912) 10:00 - 14:00
2000 (21520) 10:00 - 13:00 17:00 - 20:00
3000 (32280) 09:00 - 13:00 17:00 - 21:00
4000 (43040) 08:00 –13:00 17:00 - 22:30
5000 (53800) 07:00 –13:00 17:00 - 23:00
6000 (64560) 06:00 –13:00 17:00 - 23:59