Operation Manual

53
User’s manual
EN
Problem
Cause
Remedies
“Sync error” appears
on the display
The robot’s receiver
does not recognise
the signal
Turn the robot off and then turn it back on
again. If the problem persists, contact your
nearest authorised service centre
“Too high grass” or
“Blade Error” appe-
ars on the display
Cutting blade da-
maged
Replace the blade with a new one
(see “Blade Replacement”)
Cutting blade fouled
(tape, cords, plastic
fragments, etc.)
Stop the robot safely
(see “Robot Safety Stop”)
Use protective gloves to prevent injury.
Unclog the blade
The robot was
started too close to
obstacles (less than
a distance of m) or
in the presence of
obstacles (fallen
branches, forgotten
objects, etc.)
Stop the robot safely
(see “Robot Safety Stop”)
Remove the obstacles and restart the robot
(see “Start-up and manual stopping of the
robot (in closed areas)”)
Electric motor failure
Have the motor replaced or repaired by your
nearest authorised service centre
Too high grass
Increase the cutting height (see “Adjustment
of cutting height”)
Carry out a preliminary cutting of the area
with a normal lawnmower
The remote control
does not work
Programming error
Correctly program the remote control
(see “Programming Mode”)
The LED of the remo-
te control does not
light up
Remove the batteries and replace them
(see “Replacement of remote control batteries”)
Warning - Caution