Operation Manual

52
User’s manual
EN
“Blackout” appears
on the display
Interruption of the
power supply to the
transmitter
Restart the robot
Overheated power
supply un
Adopt the appropriate measures to reduce
the temperature of the power supply unit
(ventilate or modify the installation area, etc.)
(see “Planning of plant installation”)
Presence of other
installations nearby
Contact an authorised Service Centre
Perimeter wire
oxidised caused by
damage to the pro-
tective sheathing.
Contact your nearest authorised service
centre to check the impedance (Ohm) of the
perimeter wire
“Wheel error” appe-
ars on the display
Ground is uneven or
contains obstacles
that prevent move-
ment
Make sure the lawn to mow is even and does
not contain holes, stones or other obstacles.
Otherwise,  ll in any holes and remove any
obstacles (see “Preparation and marking the
boundaries of the work areas (primary and
secondary areas)”)
Failure of one or both
motors that operate
the transmission of
the wheels.
Have the motor replaced or repaired by your
nearest authorised service centre
“Bump Error” appe-
ars on the display
The bumper sensors
are blocked
Remove the hood and check
the functionality of the sensors
“Safety Lift” appears
on the display
Front body sensor
does not work
Makes sure the upper body is positioned
correctly. If the problem persists, contact
your nearest authorised service centre