Operation Manual

23
User’s manual
EN
Important
To set or change the password, it is fi rst necessary to enter the previous one and then enter the new one. Upon purchase,
the password entered by the manufacturer consists of four numbers (0000).
Important
When entering the password, you will be prompted to re-enter the password in order to ensure that it has been set correctly.
In order to not forget the password, choose a number combination that is easy to remember.
START PASSWORD: This function allows defi ning whether you want to enter a password each time the robot is turned on after a period of
inactivity (e.g. winter storage).
-
No: There is no need to enter a password each time the robot is turned on. The password will only be required to disable the alarm. The
robot requires the password to confi rm this parameter.
-
Yes: The password will be required each time the robot is started.
OPERATING MODE – PROGRAMMING MODE
Function for setting the operating mode of the robot. The robot automatically returns to “AUTOMATIC” mode when turned off.”
•
Automatic: Normal operating mode. The robot recognises the perimeter wire and returns to the charging station whenever necessary.
•
Closed area: Operating mode in closed areas with no charging station. For the correct use of this mode, refer to “USE OF ROBOT IN
CLOSED AREAS WITH NO CHARGING STATION.”
•
No border: Operating mode without recognition of the perimeter wire. Use in small areas whose whole perimeter is bounded by a wall or
fence at least 15 cm high, without installation of the perimeter wire and under the supervision of the user and with the remote control.
LANGUAGE OPTIONS – PROGRAMMING MODE
LANGUAGE: function for selecting the language to use for the messages and user menu. Scroll through the various options with the “+” or “-”
key and confi rm with “Enter”.
•
DATE FORMAT
•
TIME FORMAT
•
DISTANCE FORMAT
These functions allow personalising the date, time and distance formats.
INITIAL START UP – AUTOMATIC MODE
The automatic cycle is started during the initial start-up or after a period of inactivity.
1. Check that the height of the lawn surface to mow is compatible with the proper functioning of the robot (see “Technical Specifi cations”).
2. Adjust the cutting height as desired (see “Adjustment of Cutting Height).
3. Check that the work area has been correctly marked and that there are no impediments to the regular functioning of the robot as indicated
in the section “Preparation and Marking the Boundaries of the Work Areas” and following sections.
4. Position the robot inside the charging station.
5. Press the ON key and wait a few seconds for the robot to turn on completely.
6. If starting the robot for the fi rst time, it is necessary to program the settings. However, if starting the robot after a long period of inactivity,
check that the programmed functions correspond to the actual condition of the lawn to be mowed (e.g. addition of a pool, plants, etc.) (See
“Programming Mode”).
7. After a few seconds, the message “CHARGING” will appear on the display.
8. The robot starts to mow the lawn according to the modes programmed.