Operation Manual

The machine has a connector (1) for recharging located next to the battery,
which is to be connected to the corresponding connector of the special
“CB02” maintenance battery charger supplied.
This connector must only be
used for connecting to the “CB02” maintenance
battery charger. For its use:
– follow the instructions given in the relative instruc-
tions manual;
– follow the instructions given in the battery manual.
6.3 CHECKS AND ADJUSTMENTS
6.3.1 D
ISMANTLING, SHARPENING AND BALANCING THE BLADE
Check that the blade is sharpened properly and firmly fixed to the bracket.
– A badly sharpened blade pulls at the grass and causes the lawn to turn yellow.
– A loose blade causes unusual vibrations and can be dangerous.
All operations on the blade (dismantling, sharpening,
balancing, remounting and/or replacing) require a certain familiarity and
special tools. For safety reasons, go to a specialized centre if you do not
have the right tools or experience.
To dismantle the blade, hold it firmly and undo
both nuts (1) using work gloves.
Sharpen the two cutting edges using a medium
grade grinding wheel and check the balance by
holding the blade up with a round 18 mm Ø bar
inserted in the central hole.
Always replace the dam-
aged or bent blade; never try to repair it!
ALWAYS USE MANUFACTURER'S GEN-
UINE REPLACEMENT BLADES BEARING
THE SYMBOL !
On assembly, tighten
both fixing nuts (1) using a torque wrench

!
WARNING!

!
WARNING!

!
WARNING!
IMPORTANT
EN 30 MAINTENANCE
1
Ø 18 mm
1