ST IG A T U RBO 55 S ROLLER 48 S ROLLER 8211-0324-02
1 S SVENSKA 2 2 3 1 3 4 A B 2 5 6 7 8
S SVENSKA 10 9 12 13 Briggs & Stratton 14 Honda FULL 11 ADD 0,15 l.
S 17 Honda SVENSKA 18 X Y 19 21 23 4 20 Briggs & Stratton XTE 22 24 Honda GCV
S SVENSKA 26 25 T 27 40 Nm 5
GB ENGLISH SYMBOLS ASSEMBLY The following symbols appear on the machine. They are there to remind you of the care and attention required in use. This is what the symbols mean: Warning! Read the Instruction Book and Safety Manual before using the machine. LOOSE PARTS IN THE BOX 1 ignition key (*) 1 battery charger (*) 1 socket wrench 2 nut caps + Instruction books FLAP Warning! Keep onlookers away. Beware of objects being flung out. Install the flap according to fig. 1-2.
GB ENGLISH VARIATOR CONTROL CHECK THE OIL LEVEL When the mower is delivered, the variator cable is set so that the transmission cannot be damaged. The cable may need tightening, see under heading “ADJUSTING VARIATOR CABLE“ in the section “MAINTENANCE“. Check before using the machine that the oil level is between ‘FULL/MAX’ and ‘ADD/MIN’ on the dipstick. GRASS COLLECTOR Fit the fabric bag over the steel frame and then snap the bag onto the plastic lid (fig. 11).
GB ENGLISH 5. Press the Start/Stop loopG towards the handle. NOTE! The Start/Stop loopG must be kept pressed in to prevent the engine stopping (fig. 16). 6a Manual start: Grasp the starter handle and start the engine by pulling briskly on the starter cord. 6b Electric start (*): Start the engine by turning the ignition key clockwise. Release the key as soon as the engine starts. Always make short attempts at starting in order to prevent discharging the battery.
GB ENGLISH Do not set the cutting height so low that the blade comes into contact with uneven ground. The mower has single-lever control for adjusting the cutting height. Pull the lever out, and set the cutting height to one of the positions best suited to your lawn (fig. 19). MAINTENANCE No servicing may be carried out on the engine or lawnmower without first removing the spark plug cable from the spark plug. Stop the engine and remove the spark plug cable if the mower is to be lifted, e.g.
GB ENGLISH Change the spark plug if the electrodes are excessively burnt or if the plug is damaged. The engine manufacturers’ recommendations are as follows: Briggs & Stratton: Champion J19LM (RJ19LM), Spark gap 0.76 mm. 1. When the clutch loop is released, it should be possible to push the mower without any resistance. If this is not the case, screw in the nipple T until the mower can be pushed (fig. 26). 2. When the clutch loop is pressed in approx.
ENGLISH GB To replace the blade, undo the screw (fig. 27). Fit the new blade so that the stamped logo is turned up facing the blade holder (not facing the grass). Reinstall as illustrated. Tighten the screw properly. Tightening torque 40 Nm. When replacing the blade, the blade screw should also be replaced. The guarantee does not cover damage to the blade, blade holder or engine caused by running into obstacles. When replacing the blade, blade holder and blade screw, always use genuine spare parts.
M OW I N G A H E A D G G P S w e d en A B · B ox 1 00 6 · S E- 5 73 28 T R A N Å S w w w. s t i g a .
