Operation Manual

17
EN
ENGLISH
(Translation of the Original Instructions)
7.6 CHECKING THE TRANSMISSION FLUID
LEVEL
 
see 9.7.1.
7.7 SAFETY CHECKS
When trying out the machine, check that the
results of the safety checks correspond with the
indications provided in the following tables.
 -
fore use.
If any of the results fails to match the
    
table, do not use the machine! Take it
to a service centre to be checked and
repaired if necessary.
7.7.1 General safety check
 Result
Fuel lines and
connections.
No leaks.
Electrical cables. All insulation intact.
No mechanical damage.
Exhaust system. No leaks at connections.
All screws tightened.
Engine supports
The bolts which secure
the engine to the supports
are correctly tightened.
Oil lines No leaks. No damage.
Drive the ma-
chine forwards/
backwards and
release the driving-
service brake
pedal.
The machine will stop.
Test driving No abnormal vibrations.
No abnormal sound.
7.7.2 Electrical safety check
Status Action Result
The clutch-brake
pedal is not pres-
sed.
The PTO is not
activated.
Try to start
the machine.
The engine
will not
start.
Engine running. The driver
gets up from
the seat.
The engine
is switched
o.
The clutch-brake
pedal is not pres-
sed.
The ignition key
is in the operating
position.
The acoustic
signalling
device is
active.
Press the
“clutch-bra-
ke” pedal.
Start the
engine and
take it up to
operating
speed.
The signal
switches
o.
7.8 START-UP / OPERATION
When using the machine, the bonnet
must be closed and fastened shut.
 
machine.
7.8.1 Start-up
1. Activate the parking brake (12:B)
2. Check that the battery cables are correctly
connected.
3. Engage the transmission (16:A) (17:A, 17:B)
- (lever in).
4. Sit in the driving seat.
5. Keep the service brake/drive pedal free
(12:F).
6. Turn the throttle to full on (13:A, 14:A)
7. Turn the ignition key to the operating posi-
tion, see 6.10.
8. Disengage the PTO (13:E, 14:E).
9. Turn the key in the ignition to the “start en-
gine” position and start the engine.
 
      -
  


 
machine.
7.8.2 Operation
To work with the machine:
• Press the pedal (12:B) right down then release
it.
• Activate the pedal (12:F) to move the machine.
• Go to the work area.