Operation Manual

16
EN
ENGLISH
(Translation of the Original Instructions)
7 START-UP AND OPERATION
7.1 PRECAUTIONS FOR USE
     
is correct. This is particularly important

 
slopes: avoid abrupt starts and stops,
do not run the machine transversally
to the slope but run from top to bottom
and vice versa.
Apply the parking brake when you park the
machine.
The machine may not be driven on slo-
pes greater than 10º in any direction.
 
making sharp turns in order to retain
control of the machine and reduce the
risk of overturning.
        
-
chine may overturn.
 
-

7.2 COMBINED USE OF ACCESSORIES
For the combined use of accessories,
please refer to the “TABLE FOR THE
CORRECT COMBINATION OF ACCES-
SORIES” in section “0 TECHNICAL
DATA TABLE”
7.3 REFUELLING
Use only the prescribed types of fuel.
For the capacity of the fuel tank and the type of
fuel to be used, please refer to “0 TECHNICAL
DATA TABLE”.
The transparency of the tank allows the user to
check the level easily.
Do not use rapeseed-based biodiesel
(RME).
NOTE! Further information on the type
of fuel to be used can be obtained from
the engine supplier.
Filling the fuel tank over the MAX level


 
up.
To ll up with fuel:
1. Open the bonnet (see 5.2).
2. Open the fuel cap (23:A).
3. Fill with fuel up to the MAX level.
4. Close the fuel cap.

Use winter fuel or add kerosene when the ambient
temperature drops below 0°C
 
the fuel, adhere to the parameters pro-

Ambient opera-
ting temperature
in °C
Quantity of kerosene to be
added
Summer fuel Winter fuel
From 0 to -10 20 % -
From -10 to -15 30 % -
From -15 to -20 50 % 20 %
From -20 to -30 - 50 %
7.4 FUEL CIRCUIT PRIMING
Prime the fuel circuit in the following cases:
• When the fuel tank has run dry or air has got
into the fuel circuit.
• After replacing the lter.
To prime the circuit:
1. Fill the fuel tank.
2. Pump the hand pump (24:A) to send fuel
through the transparent lter (24:B) until it
is almost full (usually 4 or 5 pumping actions
suce).
7.5 CHECKING THE ENGINE OIL LEVEL (25)
The machine is delivered complete with engine oil.
Before starting the machine check the
level of the engine oil.
To check / top up the engine oil, see
9.5.1.