COMBI 8211-3442-05 D 45 45S 45SE DEUTSCH
S SVENSKA A B 1. 2. 3. 4. 2 3 4 1 FULL ADD FULL ADD FULL 6. LS45 0,15 l. ADD 6 5 5. 7.
S SVENSKA 3x 3x 8. LS45 9. ES45 G STOP I* 10. 11. A A F A 12. 13. LS45 F 14. ES45 4 15.
S SVENSKA 16. ES45 17. Left 19. LS45 20. ES45 18. Right 0,75 mm 21. 22. 23. 24.
S SVENSKA 25. 26. 45 Nm 27. 28. P S 29.
GB ENGLISH SYMBOLS ASSEMBLING The following symbols are displayed on the machine in order to remind you about the safety precautions and attention necessary when using the machine. The symbols mean: Warning! Read the Instruction Book and Safety Manual before using the machine. Warning! Keep spectators away. Beware of objects being flung out. Warning! Do not put hands or feet under the cover of the machine when it is running.
GB ENGLISH 2. COLLECTION STARTING THE ENGINE Assemble the enclosed grass collector (fig. 5). Open the cover, remove the plug and this time hook the collector in place onto the back of the machine. 1. Place the lawn mower on flat, firm ground. Do not start in high grass. During cutting, the grass is collected in the collector. Empty the grass on the compost heap or spread it out on the flower bead as fertilizer. The machine is also excellent for collecting leaves in the autumn.
GB ENGLISH 2. If the lawn mower is left unattended to, remove the lead from the spark plug. Also remove the starter key (*). If grass has dried on to the cutterhead casing it can be removed by scraping. If necessary, give the underside a touch of paint to prevent rusting. If the start/stop loop no longer works, stop the engine by removing the lead from the spark plug. Immediately take the lawn mower to an authorised workshop for repairs.
GB ENGLISH CHANGING OIL BATTERY (*) Replace the oil when the engine is warm and the fuel tank is empty. Take care while draining as the oil is hot, this is to prevent burns. Electrolyte in the battery is toxic and corrosive. It can cause serious corrosion damage etc. Avoid all contact with skin, eyes and clothing. Change the oil the first time after 5 hours of operation, and subsequently after every 50 hours of operation or once a season.
GB ENGLISH Always check the blade(s) after an impact. First disconnect the ignition cable. If the blade system has been damaged the defective parts must be changed. Always use genuine spare parts. To change blades, loosen the blade bolt. Mount the new blade so that it sits in the same way as the old one and tighten the blade bolt (fig. 27). Tightening torque: 45 Nm. When replacing the blade, the blade bolt should also be replaced.
