Operation Manual

wait a few minutes for the oil to warm
up.
Warm start.
1. Engage the transmission (15:A1-B1)
2. Activate the parking brake (10:B)
3. Turn the throttle to full on (12:E)
4. Turn the ignition key and start the engine.
To proceed see the instructions provi-
ded in heading 7.6.1.
7.7.1 Operation
To operate with the machine proceed as described
below:
• Press the pedal (12:B) right down then release
it.
• Activate the pedal (12:D) to move the machine.
• Go to the work area.
• If front accessories have been installed, activate
the PTO (13:A).
• Commence work.
7.8 STOPPING
To stop the machine, proceed as follows:
• Disengage the PTO (13:A).
• Engage the parking brake (12:B)
• Allow the engine to idle 1-2 mins.
• Turn o the engine by turning the ignition key.
• Shut o the petrol cock. This is particularly
important if the machine is to be transported on
a trailer for example.
If you have to leave the machine unat-
tended, disconnect the spark plugs and
remove the key from the ignition.
The engine may be very warm immedia-

    

7.9 CLEANING
 -
ne, silencer, battery and fuel tank free
from grass, leaves and oil.
      
check the machine for oil and/or fuel
leaks.
     
This can damage shaft seals, electrical
components or hydraulic valves.
  -
      

Always clean the machine after use. To clean
the machine adhere to the instructions provided
below:
• Do not spray water directly onto the engine.
• Clean the engine with a brush and/or
compressed air.
• Clean the motor cooling air intake.
• After cleaning using water, start the machine
and any cutting decks to remove any water
which may otherwise end up in the bearings
and cause damage.
8 USING THE ACCESSORY
Make sure the grass to be cut is com-
 
stones etc.
8.1 CUTTING HEIGHT
For best results, cut o the top third of the grass.
See g. 32.
If the grass is long and needs cutting back signi-
cantly, cut twice using two dierent cutting heights.
Do not use the lowest cutting heights if the lawn
surface is uneven.
This would entail a risk of the cutting devices being
damaged against the surface and the lawn’s top
layer of soil being removed.
8.2 MOWING TIPS
To get the best mowing results, follow the tips
given below.
• Cut grass frequently.
• Run the machine at full revs.
• Grass should not be wet.
EN
ENGLISH
(Translation of the Original Instructions)
17