User Manual

English
WWW.STIEBEL-ELTRON.COM PSH UNIVERSAL EL| 29
INSTALLATION
COMMISSIONING
11. Commissioning
11.1 Commissioning
 Open the shut-off valve in the cold water line.
 Open a draw-off point until the appliance has filled up and
the pipework is free of air.
 Observe the maximum permissible flow rate with a fully
opened tap (see chapter "Specification / Data table").
 Switch the mains power ON. The appliance carries out a
self-test.
 Check the function of the appliance.
 Check the function of the safety valve.
11.1.1 Appliance handover
 Explain the appliance function to users and familiarise them
with its operation.
 Show the user the safety valve and its operating instructions,
and explain its significance.
 Make the user aware of potential dangers, especially the risk
of scalding.
 Hand over these instructions.
11.2 Returning into use
See chapter "Commissioning".
12. Settings
12.1 Switching on commercial mode
26�02�07�0296
S Jumper ECO (energy saving mode)
E ECO ON (factory setting)
A ECO OFF (commercial mode)
 To switch on commercial mode, replug the jumper.
12.2 Switching on reverse control
26�02�07�0296
R Reverse control jumper
E Reverse control ON
A Reverse control OFF (factory setting)
 To switch on reverse control, replug the jumper.
13. Taking the appliance out of use
 Disconnect the appliance from the mains at the MCB/fuse in
the fuse box.
 Drain the appliance. See chapter "Maintenance / Draining the
appliance".