Installation Sheet

10 | MINI
™
-E SERIES TANKLESS ELECTRIC WATER HEATERS WWW.STIEBEL-ELTRON-USA.COM
INSTALLATION
10.2.2 Appliance installation
Note:
 Mount the appliance on the wall.
The wall must have a suffi cient load-bearing capacity for
the weight of the device.
d
c
e
26_02_05_0083
1 Undo the cover screws by two turns.
2 Undo the snap fastener using a screwdriver.
3 Remove the appliance cover with the heater towards the front.
26_02_05_0084
1
1 Knockout for hard-wiring
 Using pliers, break out the knock-out for the power cable in the
appliance cover. Correct the contours with a fi le if necessary.
 Use the appliance back panel as a drilling template.
 Secure the appliance back panel to the wall with suitable plugs
and screws.