Operating Instructions and Installation Instructions

34 |DHE SLi www.stiebel-eltron.com
INSTALLATION
Installation
Mounting bracket for appliance replacement
Am existing StiebelEltron mounting bracket may be used when
replacing appliances (except instantaneous water heater DHF).
 Break through the back panel of the appliance for the thread-
ed stud on the pre-installed mounting bracket.
DHF replacement
26�02�02�0815�
 Reposition the threaded stud on the mounting bracket (the
stud has a self-tapping thread).
 Rotate the mounting bracket through 180° and mount it on
the wall (the DHF logo is then turned towards the reader).
Installation with offset tiles
110
20
26�02�02�1066�
2
1
1 Minimum contact area of the appliance
2 Maximum tile offset
 Adjust the wall clearance and lock the back panel with the
fixing toggle by turning it clockwise through 90°.
Turned appliance cover
The appliance cover can be turned for undersink installation.
electr onic
comfor t
electr
onic comf or
t
26�02�02�0553
 Remove the programming unit from the appliance cover by
pressing the locking hooks and taking out the programming
unit.
 Turn the appliance cover (not the appliance) and refit the
programming unit, ensuring that all locking hooks click into
place. When clicking the locking hooks into place, make sure
you press against the inner side of the appliance cover (shad-
ed area).
 Plug the set value transducer cable into the PCB (see chapter
"Commissioning").
 Hook the appliance cover back in at the bottom and pivot it
up onto the back panel.
 Ensure the all-round seal of the back panel sits tightly by
pushing the cover gently forwards and back.
 Secure the appliance cover.
Operation with preheated water
By installing a central thermostatic valve you will limit the max-
imum inlet temperature (see chapter "Appliance description/
Accessories").