Operating Instructions and Installation Instructions
ENGLISH
10.2.7 Fitting the sieve
Fit the sieve provided in the cold water inlet of the appliance.
Note
The sieve must always be fitted for the function of the
appliance to be guaranteed. If an appliance is being
replaced during installation, ensure that a sieve is
available.
26�02�02�0856
10.2.8 Installing the DMB flow limiter
Position the flow limiter provided in the cold water inlet of
the appliance.
A second flow limiter is provided with the DHB-E 18/21/24 SLi.
Install the flow limiter with an output corresponding to that of
the appliance.
Flow limiter, see "flow rate limit" in chapter "Specification":
4.0 l/min = pink
7.5 l/min = blue
8.5 l/min = green
26�02�02�0857
10.2.9 Mounting the appliance
The cable grommet pointing towards the wall may hinder the
mounting of the appliance close to the wall. To prevent such
problems, it is advisable to briefly press the cable grommet from
behind into the back panel, to reduce the stiffness or the grommet.
Remove the fixing toggle from the upper part of the back
panel (diagram "Mounting the appliance").
Route the power cable from behind through the cable
grommet until it rests against the cable sheath. Align the
power cable. If the cross-section of the power cable is
greater than 6mm, enlarge the hole in the cable grommet
(see also "Power supply for larger cross-sections").
Push the appliance over the stud of the mounting bracket, so
that it breaks through the soft seal. If necessary pierce the
soft seal with a screwdriver.
Put the fixing toggle onto the stud of the mounting bracket
that penetrates the back panel.
Press the back panel firmly into place and lock the fixing
toggle by turning it through 90°.
26�02�02�0811
10.2.10 Finalising the water connection
26�02�02�0858
10.2.11 Connecting the power supply
Connect the power cable to the mains terminal (see chapter
"Wiring diagram").
WARNING Risk of electrocution
Ensure that the appliance is connected to earth.
26�02�02�1122�