Operating Instructions and Installation Instructions

 


10.1.2 Oversink
2 1
26�02�02�0806
1 Cold water inlet
2 DHW outlet
10.2 Installation
10.2.1 Opening the appliance
26�02�02�0808
10.2.2 Removing the back panel
26�02�02�1101
 Press the two locking hooks on the r.h. and l.h. side and
remove the lower part towards the front.
10.2.3 Fitting the mounting bracket
 Mark out the holes for drilling using the installation template.
If the appliance is to be installed with water connections
for finished walls, the fixing hole in the lower part of the
template must also be marked out.
 Drill the holes and secure the mounting bracket with
twoscrews and two rawl plugs. The screws and rawl plugs
are not part of the standard delivery.
26�02�02�0810�
10.2.4 Fitting the power cable
160
30
26�02�02�0824
 Prepare the power cable.
 Use the plastic cap as an installation aid.
10.2.5 Inserting the twin nipples
26�02�02�0798
10.2.6 Preparing the water connection
 Secure the tee and cross-piece to the twin nipples with flat
packing.
 Thoroughly flush the cold water supply line.
Note
Never use the three-way shut-off valve to reduce the flow
rate; it is only designed to shut off a circuit.
1 2
26�02�02�0799
1 Tee
2 Cross-piece