Operating Instructions and Installation Instructions

 


10.2.12 Fitting the lower back panel
26�02�02�1102�
10.2.13 Completing the installation process
 Align the mounted appliance by loosening the fixing
toggle, aligning the power supply and back panel, and
then retightening the fixing toggle. If the back panel of the
appliance is not flush against the wall, the appliance can be
fixed with a screw in the lower part.
10.3 Installation versions
10.3.1 Power supply from above for unfinished walls
The following diagram shows the dimensions for the power supply
from above.
26�02�02�0802
To connect the power supply, take the following steps:
 Open out the cable grommet to match the cross-section of
the power cable.
 Push down and remove the locking hook that secures the
mains terminal.
 Move the mains terminal in the appliance from the bottom to
the top and click into place.
26�02�02�1123�
10.3.2 Power supply for finished walls
The appliance can also be connected if the power supply has been
routed over finished walls. This applies to the connection from
below and above. Take the following steps:
 Cut or break knock-outs in the back panel and appliance
cap. Possible knock-out points can be seen in the diagram
"Dimensions for power supply".
Note
If the appliance has been connected with a power supply
on finished walls, the type of protection on the type plate
must be changed from IP 25 to IP 24. Use a permanent
marker for that.
 Cross out "IP 25" and mark the box "IP 24".
10.3.3 Power supply for large cross-sections
1.
3.
4.
2.
26�02�02�1124�
If cables with a large cross-section are used, the cable grommet
can be fitted after the appliance has been installed. Take the
following steps:
 Before installing the appliance, use a screwdriver to push the
cable grommet out.