Instructions / Assembly

22 | Accelera® 220-300 E www.stiebel-eltron-usa.com
INSTALLATION
Preparations
10.4 Siting the appliance
f Carefully undo the cardboard packaging at the clips.
D0000034797
1
1 Cardboard packaging clips
The appliance is secured to the pallet with metal brackets and
screws. The metal brackets are hooked on to the feet underneath
the floor plate of the appliance.
1.
2.
D0000034798
1
1 Metal bracket fixing bolt
f Remove the fixing bolts of the metal brackets from the pallet.
f Push the metal brackets a little towards the tank center, to
unhook them from the appliance feet.
f Pull the metal brackets out from underneath the appliance.
!
Material losses
Take note of the appliance's weight and top-heaviness.
f Slightly tip the appliance and carefully roll the appliance off
the pallet.
f Bring the appliance in its final location.
10.5 Minimum clearances
14˝
(0.4 m)
2´ (0.6 m)
8˝ (0.2 m)
6´ (1.8 m)
Air flow
intake
Air flow
intake
Air flow
exhaust
Air flow
exhaust
2´ (0.6 m)
Air flow
intake
Air flow
exhaust
6´ (1.8 m)
Minimum room volume:
800
ft
3
, 10´ x 10´ x 8´
(22.7 m
3
, 3 m x 3 m x 2.4 m)
Acceptable positioning, vent parallel to a wall:
Acceptable positioning, vent parallel to a wall in a corner:
2´
(0.6 m)
2´
(0.6 m)
8˝ (0.2 m)
8˝
(0.2 m)
6´
(1.8 m)
[300E]
≤60˝
(≤1.5 m)
[220 E]
≤42˝
(≤1.1 m)
f Maintain the minimum clearances.
!
Material losses
The top of the appliance should be made horizontal.
f Level the appliance horizontally using the
height-adjustable feet.
D0000034806