User guide

• If the Bell Box fails to alarm, check the following:
· House Security Settings are the same as for the Wire-Free Home Alarm
Smart Panel.
· The ON/OFF switch on the Bell Box is set to the ON position.
· The Bell Box is in a location where it can receive a good signal from the
Wire-Free Home alarm Smart Panel.
• When the Bell Box is switched to ON, removing the Bell Box from the wall
surface will trigger the Bell Box siren immediately.
• When the battery is running low and needs replacement, the LED indicator on
the Bell Box will blink very quickly. In this case follow the battery replacement
procedure as described in Section 3.1.
4. House Security Code Settings
Unless the factory settings of the Wire-Free Home Protection System Smart Panel
have been altered, the House Security Code will NOT need to be changed. However,
if the settings on the Smart Panel have been altered, or need to be altered to solve
the problem of the Smart Panel and sensors activating intermittently (or not working
at all) or interference with other systems, then the House Security Code on all system
modules, including the Indoor Siren, will also need to be changed.
House Security Code settings can be altered as follows:
• There are 4 jumpers or dip-switches on each device.
• Remove the [jumper compartment cover], then pull out or plug the jumper into
the contacts to change the House Security Code.
• If a jumper is plugged it is ON, if it is removed it is OFF. Default code is with all
the jumpers plugged.
• To ensure the system works correctly, make sure the jumpers on the Smart
Panel and all other system modules (sensors and sirens) match exactly.
ON
1 2 3 4
ON DIP
4 3 2 1
Jumpers for
house security
code
Dip-Switches
for house
security code
- Smart Panel
- Each sensor
Default house code:
1: ON, 2: ON, 3: ON, 4: ON
*Jumper: ON = Plugged, OFF = Pull Out
- Key Fob Remote
Default house code: 1: 0N, 2: 0N, 3: ON, 4: 0N
5. Maintenance
Unless the factory settings of the Wire-Free Home Protection System Smart Panel
The product may be cleaned with a soft damp cloth and then wiped dry. Do not use
abrasive, solvent based or aerosol cleaners as this may damage and/or discolor the
product. Do not allow water to enter or attempt to clean inside the unit.