User guide

ManualsBrandsSTI ManualsSafety7525

Protective Cabinet

STI-7524 and STI-7525

Features

• Clear, protective polycarbonate cover with siren/strobe alarm.

• Design allows visibility at any angle.

• Complete with mounting hardware and gasket.

• Includes backplate and siren/strobe alarm.

• External mounting tabs or internal drill dimples.

• Cover includes a coated steel internal mounting plate with a baked on white

enamel finish.

• Siren/strobe alarm lens is red. Also available with amber, green, blue or white lens.

• Siren offers 32 user selectable tones.

• Alarm can be set for a piercing 100 or 85 dB.

• Independent strobe and siren timing of 15 seconds, 30 seconds, 60 seconds or

continuous.

• Powered by a 9 VDC battery or external 12-30 volts.

• Low battery indicator.

We protect the things that protect you.

Summary of content (8 pages)

PAGE 1
Protective Cabinet STI-7524 and STI-7525 Features • • • • • • • • • • • • Clear, protective polycarbonate cover with siren/strobe alarm. Design allows visibility at any angle. Complete with mounting hardware and gasket. Includes backplate and siren/strobe alarm. External mounting tabs or internal drill dimples. Cover includes a coated steel internal mounting plate with a baked on white enamel finish. Siren/strobe alarm lens is red. Also available with amber, green, blue or white lens.
PAGE 2
CONTENTS Warnings ..................................................................................................page 2 Cleaning Instructions ..............................................................................page 2 Dimensions ..............................................................................................page 3 Specifications ..........................................................................................page 3 Installation of Cabinet ..................................
PAGE 3
DIMENSIONS 3.29 in. (83.95mm) 12.49 in. (317.35mm) 19.46 in. (494.34mm) 1/4” DIAMETER 7.11 in. (180.64mm) 4.80 in. (121.
PAGE 4
INSTALLATION OF CABINET Note: Installation of cabinet should be before installation of alarm because the mounting bracket butts up to cabinet. 1. Insert the (4) 06298 mounting tabs fully into back box mounting tab slots. Use rubber mallet if necessary. 2. After selecting a suitable location, place cabinet in closed position, against the wall. Mark and drill (4) 1/4 in. diameter holes. Insert the (4) 19033 anchors. Mount cabinet by driving in the four #10 x 1 1/2 in. screws.
PAGE 5
O STEP 2 - ELECTRONIC SETUP - SELECT ALARM TONE AND TIMING SEQUENCE S1 SIREN ALARM TONE S2 ALARM TIMING STROBE TIMING VOLUME LED QTY 10 BATTERY LOW BATTERY INDICATOR LED TERMINAL STRIP BATTERY CABLE WIRE ENTRY TAMPER SWITCH (REAR VIEW) NOTE: Select-Alert must be on a flat surface and lens must be installed or the tamper switch will trigger the alarm.
PAGE 6
STEP 5 - ELECTRONICS ASSEMBLY Wiring: After mounting circuit board assembly, connect wires. Refer to terminal strip connections (step 6). Lens installation: Slide lip of lens behind circuit board mounting plate. Rotate lens into position. Secure with tamperproof screw and special wrench. ! Unit will not operate properly if lens cover is not installed.
PAGE 7
ASSEMBLY PARTS LIST SIREN/STROBE ALARM QTY. PART # 1 1 1 2 1 1 4 2 2 1 1 1 05000 05050-R 09723 18075 18074 18151 19002 19039 19018 19011 19016 BAT-9VDC DESCRIPTION Electronics assembly (includes base plate & electronics assembly) Red lens (unless otherwise specified) Key switch mounting bracket #801 key Switch lock N.C. reed switch and magnet (installed in cabinet) Screw #8-32 x 3/8 in. Screw #6 x 1 1/4 in. Anchor #8-10 #8-32 x 1/2 in.
PAGE 8
ACCESSORIES AND REPLACEMENT PARTS STI-SA5000-R Replacement Siren/Strobe Alarm 18054 Replacement key for cabinet lock on STI-7524 18075 Replacement key for Siren/Strobe Alarm 2306 Airport Road • Waterford, MI 48327 Phone: 248-673-9898 • Fax: 248-673-1246 info@sti-usa.com • www.sti-usa.com Safety Technology International (Europe) Ltd.