User's Manual

Hayes AT Reference
RFI-148 & RFI-900 High Output Power Paging Transmitters User Manual Page 98 of 134
ATP102: Returns the current value of Encoder Detected.
Enumeration values:
0 = No
1 = Yes
2 = Hot Standby
Data Idle Duration
ATP94: Returns the current value of Data Idle Duration.
Data Idle Timeout (Stored)
Configurable timeout for detecting the encoder data inputs as idle, which will cause the encoder data idle
fault to go active.
ATP95: Returns the current value of Data Idle Timeout.
ATP95=n[.m].: Sets the value of Data Idle Timeout to n s, given that 0.000 <= n <= 4294967.295.
Report Data Idle (Stored)
Enable or disable reporting of idle encoder data fault.
ATP96: Returns the current value of Report Data Idle.
ATP96=n sets Report Data Idle to n.
Enumeration values:
0 = False
1 = True
4-Level Operation (Stored)
Allows swapping of L-/H-bit.
ATP124: Returns the current value of 4-Level Operation.
ATP124=n sets 4-Level Operation to n.
Enumeration values:
0 = Normal
1 = Legacy
Encoder Protocol Control (Stored)
Allows the active protocol profile to be toggled by hardware input.
ATP99: Returns the current value of Encoder Protocol Control.
ATP99=n sets Encoder Protocol Control to n.
Enumeration values:
0 = Disabled
1 = Enabled
Encoder Channel Control (Stored)
Allows the active channel to be toggled by hardware input.
ATS180: Returns the current value of Encoder Channel Control.
ATS180=n sets Encoder Channel Control to n.
Enumeration values:
0 = Disabled
1 = Enabled
Encoder Hardware PTT (Stored)
Allows transmitter PTT to be controlled by hardware input.
ATP97: Returns the current value of Encoder Hardware PTT.