User's Manual

Hayes AT Reference
RFI-148 & RFI-900 High Output Power Paging Transmitters User Manual Page 79 of 134
0 = Disabled
1 = Enabled
Paging Protocols Menu
POCSAG Deviation
ATP105: Returns the current value of POCSAG Deviation.
FLEX Deviation
ATP106: Returns the current value of FLEX Deviation.
Encoding Mode (Stored)
Configure the encoding source for paging transmitter data.
ATN10: Returns the current value of Encoding Mode.
ATN10=n sets Encoding Mode to n.
Enumeration values:
0 = External Encoder
1 = TNPP Serial
2 = TNPP TCP:64250
3 = TNPP UDP:64250
4 = PET/TAP Serial
5 = PET/TAP TCP:64250
6 = PET/TAP UDP:64250
7 = Datagram Serial
8 = Datagram TCP:64250
9 = Datagram UDP:64250
Can return the following error codes:
1 = Not supported with this firmware/hardware/FPGA
PET/TAP Menu
Current State
ATN43: Returns the current value of Current State.
Enumeration values:
0 = Idle
1 = Logon
2 = Logged In
3 = Message [Capcode]
4 = Message [Message]
5 = Message [Dest.]
6 = Message [Checksum]
7 = Logoff
8 = Not Running
9 = Pending Proxy Response
10 = Proxy Success
11 = Proxy Failure
Line Separator (Stored)
The line separator output between new lines. Configurable for compatibility across terminals.
ATN15: Returns the current value of Line Separator.
ATN15=n sets Line Separator to n.
Enumeration values: