User's Manual

Hayes AT Reference
RFI-148 & RFI-900 High Output Power Paging Transmitters User Manual Page 73 of 134
Serial Number
Factory assigned serial number for this device.
ATI6: Returns the current value of Serial Number.
Radio Menu
Current Transmit Time
Time since current transmission started (if transmitting), or zero if not currently transmitting.
ATP119: Returns the current value of Current Transmit Time.
Transmitter Idle Time
Time since last transmission ended (if not transmitting), or zero if currently transmitting.
ATP116: Returns the current value of Transmitter Idle Time.
PTT Override Status
If PTT is currently disabled, describes what is the source of the override.
ATP6: Returns the current value of PTT Override Status.
PTT Override (Stored)
Master override allowing transmission to be completely disabled, regardless of PTT inputs.
ATP7: Returns the current value of PTT Override.
ATP7=n sets PTT Override to n.
Enumeration values:
0 = Enable Transmit
1 = Disable Transmit
PTT Turn Off Delay (Stored)
Delay before turning off the transmitter after PTT off is signalled.
ATP112: Returns the current value of PTT Turn Off Delay.
ATP112=n[.m].: Sets the value of PTT Turn Off Delay to n s, given that 0.000 <= n <= 65.535.
Enable Transmit Timeout (Stored)
Enable or disable the transmit timeout feature.
ATP117: Returns the current value of Enable Transmit Timeout.
ATP117=n sets Enable Transmit Timeout to n.
Enumeration values:
0 = False
1 = True
Transmit Timeout (Stored)
Continuous transmission time, in seconds, which will cause a Transmit Timeout fault to occur. By default
this will disable further transmission until the fault is cleared.
ATP118: Returns the current value of Transmit Timeout.
ATP118=n[.m].: Sets the value of Transmit Timeout to n s, given that 0.000 <= n <= 4294967.295.
Absolute Delay Adjustment (Stored)
Applies an artificial transmission delay to all data. Can be used for matching delay in heterogeneous
transmitter networks.
ATI154: Returns the current value of Absolute Delay Adjustment.
ATI154=n[.m].: Sets the value of Absolute Delay Adjustment to n ms, given that 0.000 <= n <= 40.000.
Can return the following error codes: