User's Manual

Management Reference
RFI-148 & RFI-900 High Output Power Paging Transmitters User Manual Page 69 of 134
rfiPageProtSelect
R/W
Active protocol profile.
rfiPageProtTblOffset
R/W
Configured carrier frequency offset for this profile.
rfiPageProtTblProt
R/W
Configured paging protocol for this profile.
Radio Parameters
rfiRadioFrqChSelect
R/W
Currently selected radio channel number.
rfiRadioFrqChTblNo
R
Radio channel number.
rfiRadioFrqChTblTxfrq
R/W
Radio channel transmit frequency.
rfiRadioFrqRefCur
R
The current reference being used to generate channel frequencies.
rfiRadioFrqRefExt
R
The state of the external reference.
rfiRadioFrqRefMode
R/W
The reference selection method.
rfiRadioIsolatorFeed
R
Hardware feedback from the isolator attentuation switchout
mechanism.
rfiRadioIsolatorMode
R/W
Sets the isolator for normal transmission (high attenuation on RF
diag port) or for listening to signal from antenna, for network
testing (low attenuation on RF diag port, transmission disabled).
rfiRadioTxDelay
R/W
Applies an artificial transmission delay to all data. Can be used for
matching delay in heterogeneous transmitter networks.
rfiRadioTxIdletime
R
Time since last transmission ended (if not transmitting), or zero if
currently transmitting.
rfiRadioTxOntime
R
Time since current transmission started (if transmitting), or zero if
not currently transmitting.
rfiRadioTxPttAuto
R/W
Setting to enable or disable the automatic Push-To-Talk on data
feature.
rfiRadioTxPttAutoTmout
R/W
No-data timeout for the automatic PTT feature.
rfiRadioTxPttOverride
R/W
Master override allowing transmission to be completely disabled,
regardless of PTT inputs.
rfiRadioTxPttStatus
R
If PTT is currently disabled, describes what is the source of the
override.
rfiRadioTxPttTofftime
R/W
Delay before turning off the transmitter after PTT off is signalled.
rfiRadioTxPwrCtrlLvl
R/W
Transmitter output power setting.
rfiRadioTxStatus
R
Current transmission status. May be off, on, or waiting for PTT
delay to expire before turning off.
rfiRadioTxTimeout
R/W
Continuous transmission time, in seconds, which will cause a
Transmit Timeout fault to occur. By default this will disable
further transmission until the fault is cleared.
rfiRadioTxTimeouten
R/W
Enable or disable the transmit timeout feature.
Sensors
rfiSensTblCutoffHi
R/W
Upper cutoff value for this sensor. Measurements which exceed