User's Manual

Configuration
RFI-148 & RFI-900 High Output Power Paging Transmitters User Manual Page 21 of 134
Figure 10: Separate AT commands
Alternatively, they can be concatenated and run as a sequenced command:
Figure 11: Sequenced AT command
3.6 Front Panel Interface
The front panel interface consists of six status LEDs and a transmit power gauge. The panel is illustrated in
Figure 12 and the function of each LED is described in Table 4.
LED
Colour
Description
Transmit On
Green
Turns on when the transmitter is on.
Fault
Red
Turns on when any fault is active. Will flash in unison with the
Serial/Ethernet LED if there are serial errors.
Low Power
Red
Turns on when the sensed transmit power is lower than the
lower cut-off value as specified in the sensor parameters.
High VSWR
Red
Turns on when the isolator VSWR is higher than the higher cut-
off value as specified in the sensor parameters.
Serial/Ethernet
Green
Flashes when serial or Ethernet data is transmitted or received.
Power
Green
Turns on/off at 1 Hz while power is supplied.
Power Gauge
Green/Red
A bar graph displaying current transmit power.
Table 4: Front panel LED descriptions
ATI6
F00012K01000
OK
ATS54
1
OK
ATS100[0]
8
OK
ATI6S54S100[0]
F00012K01000
1
8
OK