User's Manual

Hayes AT Reference
RFI-148 & RFI-900 High Output Power Paging Transmitters User Manual Page 109 of 134
EEPROM Status
Displays the EEPROM status at start-up. Blank or Invalid EEPROM could indicate a hardware fault.
ATR10: Returns the current value of EEPROM Status.
Enumeration values:
0 = Valid
1 = Blank or Invalid
Build Date
The date the firmware was compiled.
ATR9: Returns the current value of Build Date.
Firmware Version
Version information for the firmware loaded in this device.
ATI4: Returns the current value of Firmware Version.
FPGA Version
Version information for the FPGA image loaded into this device.
ATI18: Returns the current value of FPGA Version.
Bootloader Version
ATI130: Returns the current value of Bootloader Version.
(Distributer) Assertion Messages (Stored)
ATG170: Returns the current value of Assertion Messages.
ATG170=n sets Assertion Messages to n.
Enumeration values:
0 = Disabled
1 = Enabled
Software Reset
ATG10: Runs the Software Reset routine.
Time Menu
Uptime
Seconds since the radio powered up.
ATG16: Returns the current value of Uptime.
Local Time
The current local time (in seconds since Jan 1 1970).
ATG11: Returns the current value of Local Time.
Battery Status
ATG13: Returns the current value of Battery Status.
Enumeration values:
0 = Good
1 = Low Battery
2 = N/A
Local Time
The current local time.
ATG12: Returns the current value of Local Time.