User's Manual

Hayes AT Reference
RFI-148 & RFI-900 High Output Power Paging Transmitters User Manual Page 107 of 134
Get or set the 3rd Octet of either IP address, subnet mask or gateway.
ATI82[a]: Returns the current value of 3rd Octet.
ATI82[a]=n.: Sets the value of 3rd Octet to n , given that 0 <= n <= 255.
Where: a = Static IP Configuration table index (starting from 0).
Can return the following error codes:
1 = Power must be cycled to apply this change.
2 = Invalid hostname. Must only contain digits, letters and hyphens. Cannot start or end with hyphen.
4th Octet (Identity)
Get or set the 4th Octet of either IP address, subnet mask or gateway.
ATI83[a]: Returns the current value of 4th Octet.
ATI83[a]=n.: Sets the value of 4th Octet to n , given that 0 <= n <= 255.
Where: a = Static IP Configuration table index (starting from 0).
Can return the following error codes:
1 = Power must be cycled to apply this change.
2 = Invalid hostname. Must only contain digits, letters and hyphens. Cannot start or end with hyphen.
SNTP Menu
Status
ATG8: Returns the current value of Status.
Enumeration values:
0 = -
1 = Disabled
2 = Error Sending Request
3 = Request Timed Out
4 = Request Pending
5 = Synchronised
Last Sync
ATG2: Returns the current value of Last Sync.
Last Query Latency
ATG5: Returns the current value of Last Query Latency.
Mode (Stored)
ATG1: Returns the current value of Mode.
ATG1=n sets Mode to n.
Enumeration values:
0 = Disabled
1 = Unicast
Server IP (Stored)
ATG3: Returns the current value of Server IP.
ATG3=s: Sets the value of Server IP to s, given that 0 <= length(s) <= 32.
Query Interval (Stored)
ATG4: Returns the current value of Query Interval.
ATG4=n.: Sets the value of Query Interval to n mins, given that 1 <= n <= 2880.
Request Timeout (Stored)