User's Manual

Hayes AT Reference
RFI-148 & RFI-900 High Output Power Paging Transmitters User Manual Page 106 of 134
TCP Idle Timeout (Stored)
Idle time before a TCP connection times out.
ATG48: Returns the current value of TCP Idle Timeout.
ATG48=n.: Sets the value of TCP Idle Timeout to n s, given that 0 <= n <= 65535.
UDP Idle Timeout (Stored)
Idle time before a UDP connection times out.
ATG96: Returns the current value of UDP Idle Timeout.
ATG96=n.: Sets the value of UDP Idle Timeout to n s, given that 20 <= n <= 600.
DHCP Client (Identity)
Enables or disables the DHCP client of this unit. When disabled, the unit will use the configured static IP
address.
ATI71: Returns the current value of DHCP Client.
ATI71=n sets DHCP Client to n.
Enumeration values:
0 = Disabled
1 = Enabled
Can return the following error codes:
1 = Power must be cycled to apply this change.
2 = Invalid hostname. Must only contain digits, letters and hyphens. Cannot start or end with hyphen.
Hostname (Stored)
The hostname of the unit.
ATI72: Returns the current value of Hostname.
ATI72=s: Sets the value of Hostname to s, given that 0 <= length(s) <= 26.
Can return the following error codes:
1 = Power must be cycled to apply this change.
2 = Invalid hostname. Must only contain digits, letters and hyphens. Cannot start or end with hyphen.
Static IP Configuration Table
1st Octet (Identity)
Get or set the 1st Octet of either IP address, subnet mask or gateway.
ATI80[a]: Returns the current value of 1st Octet.
ATI80[a]=n.: Sets the value of 1st Octet to n , given that 0 <= n <= 255.
Where: a = Static IP Configuration table index (starting from 0).
Can return the following error codes:
1 = Power must be cycled to apply this change.
2 = Invalid hostname. Must only contain digits, letters and hyphens. Cannot start or end with hyphen.
2nd Octet (Identity)
Get or set the 2nd Octet of either IP address, subnet mask or gateway.
ATI81[a]: Returns the current value of 2nd Octet.
ATI81[a]=n.: Sets the value of 2nd Octet to n , given that 0 <= n <= 255.
Where: a = Static IP Configuration table index (starting from 0).
Can return the following error codes:
1 = Power must be cycled to apply this change.
2 = Invalid hostname. Must only contain digits, letters and hyphens. Cannot start or end with hyphen.
3rd Octet (Identity)