User's Manual

Hayes AT Reference
RFI-148 & RFI-900 High Output Power Paging Transmitters User Manual Page 102 of 134
0 = Not Detected
1 = Detected
HS Support
ATM19: Returns the current value of HS Support.
Enumeration values:
0 = Not Supported
1 = Supported
Standby Mode (Stored)
ATM10: Returns the current value of Standby Mode.
ATM10=n sets Standby Mode to n.
Enumeration values:
0 = Disabled
1 = Hardware
2 = Software
Can return the following error codes:
1 = Not compatible with this hardware
2 = Requires a power-on-reset to take effect
Can Go Active (SW)
ATM12: Returns the current value of Can Go Active (SW).
ATM12=n sets Can Go Active (SW) to n.
Enumeration values:
0 = False
1 = True
Serial Ports Menu
Main DCD State
The state of the DCD input on the main serial port.
ATS92: Returns the current value of Main DCD State.
Main CTS State
The state of the CTS input on the main serial port.
ATS93: Returns the current value of Main CTS State.
Main Flow Control (Stored)
Configures flow control methods for the main serial port
ATS104: Returns the current value of Main Flow Control.
ATS104=n sets Main Flow Control to n.
Enumeration values:
0 = None
2 = Hardware (RTS / CTS)
Main DTR Mode (Stored)
Configures the behaviour of the DTR output on the main serial port.
ATS90: Returns the current value of Main DTR Mode.
ATS90=n sets Main DTR Mode to n.
Enumeration values:
0 = Always High
1 = Always Low