User's Manual

USING INTERNAL MENU COMMANDS

©©

234839, Revision 2.2

(F) Flow Control Menu

This option allows you to select the type of flow control between the modem and local device. Flow

Control is used to prevent data loss from a buffer overflow. The modem and terminal must use the same

type of flow control. The type of flow control is selected when the menu option is chosen. This is shown in

Figure 6-24 below. The main port and auxiliary port are configured independently however the auxiliary port

does not support hardware flow control.

*** Flow Control Menu ***

Main Port: No Flow

(H) Hardware Flow (RTS/CTS)

(S) Software Flow (XON/XOFF)

(N) No Flow

(Esc) Previous Menu

Enter Choice:

Figure 6-24 Flow Control Menu

(A) Advanced Functions Menu

For menu options please refer to (A) Advanced Functions Menu on page 34.

(M) Modem and I/O Configuration Menu

The Modem Configuration Menu in Figure 6-25 below allows the lower levels of the modem’s

operations to be configured according to user specific requirements. The selections available from this

menu are shown below. This section is designed to mimic a Hayes compatible modem.

*** Modem And I/O Configuration Menu ***

(H) Hayes Command Control Menu

(D) DCD Control Menu

(R) RTS Control Menu

(A) Auxiliary I/O Port

(Esc) Previous Menu

Enter Choice:

Figure 6-25 Modem Configuration Menu