User Manual

Appendix C Hayes AT Command Reference
RFI-9256 Radio Modem User Manual Page 83 of 96
 ATS48=0<CR> : Disables frame bias (sets the bias to 50/50).
 ATS48=1<CR> : Sets the frame bias to outgoing/upload. This means that more data can flow out
from this unit over the air.
 ATS48=2<CR> : Sets the frame bias to incoming/download. This means that more data can flow
into this unit from the air.
C.2.15 “ATS50” Network Address
S-register 40 sets the network address of the radio. All radios on a single network must have the same
network in order to communicate. Valid values are between 0 and 63.
 ATS50=54<CR> : Sets the network address to 54.
C.2.16 “ATS51” Unit Rx address
S-register 51 sets the units local address. Local addresses are in the range 0 to 9999.
 ATS51=1001<CR> : Sets the units address to 1001.
C.2.17 “ATS52” Unit Tx address
S-register 52 sets the destination address for point-to-point traffic from this unit. Destination addresses are in
the range 0 to 9999.
 ATS52=2027<CR> : Sets the point-to-point destination address to 2027.
C.2.18 “ATS60” Set Logging Level
S-register 60 sets the current radio log level. The only valid values are:
 ATS60=0<CR> : Only errors are logged.
 ATS60=1<CR> : Warnings and errors are logged.
 ATS60=2<CR> : Status information, warnings, and errors are logged.
 ATS60=3<CR> : General information, status information, warnings, and errors are logged.
 ATS60=4<CR> : All information is logged.
C.2.19 “ATS61” Set UNIX Date/Time
S-register 61 sets the real-time of the radio in seconds since 1970.
 ATS61=1<CR> : Sets the time to one second past midnight on the 1
st
of January 1970.