User Manual

Applications
RFI-9256 Radio Modem User Manual Page 47 of 96
In this situation Master 1 must route all SCADA packets that are destined for the slaves connected to Master
2 to Slave 2, the slave component of the back-to-back repeater. This routing table is shown in Table 14
Route Type RTU Address Radio Address
Single Route 21 2000:00
Range Route 40-41 30:00
Table 14: Master 1 routing table
Master 2 must then correctly route all SCADA protocol packets onto the slaves in its network. This is done
using the routing table in Table 15
Route Type RTU Address Radio Address
Mapped Route 40-41 4007:00
Table 15: Master 2 routing table
The slaves that hang off master 1 must have the following routing table shown in Table 16.
Route Type RTU Address Radio Address
Default Route N/A 1000:00
Table 16: Slaves from master 1 routing table
The slaves that hang off master 2 must have the following routing table shown in Table 17.
Route Type RTU Address Radio Address
Default Route N/A 30:00
Table 17: Slaves from master 2 routing table