Manual

30
ENGLISH
Clean the inside of the barrel as follows:
1. Screw the patch holder onto the threaded end of the cleaning string.
Insert a cleaning patch into the patch holder. Wet the cleaning patch
with a gun cleaning solvent or a cleaner-lubricant-preservative and
pull it through the barrel, from the chamber end to the muzzle end,
several times until the barrel is clean. If necessary, replace the dirty
cleaning patch with a new one during this process;
2. Unscrew the patch holder from the cleaning string and screw the
bristle brush on instead. Slightly wet the bristle brush and pull it
through the barrel once, from the chamber end to the muzzle end.
If the barrel is extremely dirty, such as when it has been fired many
times without having been cleaned, use the wire brush instead of
the bristle brush;
3. Unscrew the bristle brush from the cleaning string and screw the
patch holder back on. Wet another cleaning patch with a gun clean-
ing solvent or a cleaner-lubricant-preservative and pull it through the
barrel once, from the chamber end to the muzzle end, and examine
it. If it is not clean, repeat steps two and three until the patch re-
mains clean after being run through the barrel;
OIL BOTTLE
PATCH HOLDER
WIRE BRUSH
BRISTLE BRUSH
CLEANING STRING
CLEANING PATCH
Fig. 40
Innen USA.indd 30 04.02.2009 14:37:50 Uhr