User Manual

2.5.1 Constant Voltage

The Euro Block connector on the rear of the amplier is capable of sup-

plying output at 70V.

2.5.2 Wiring Example

The diagram below is a typical wiring setup for two speakers with out-

board step-down transformers wired in parallel to the 70V output op-

tion of a CVA50-1 Priority PA amplier.

3 Operation

3.1 Operating Precautions

1. Before use, your amplier must be congured for proper opera-

tion, including input and output wiring hookup. Improper wiring

can result in damage to equipment or potentially harm to the

operator. Consult section 2 for setup instructions.

2. Tampering with the circuitry, or making unauthorized changes

is not only dangerous but may also violate local regulations.

3. Use care when making connections between the amplier and

the input or output equipment. Using equipment that is not

capable of handling the output wattage may lead to permanent

damage.

NOTE: Stewart Audio will not be held responsible for

damage to your CVA50-1 Priority PA amplier or connect-

ed equipment if the instructions in this manual are not

followed.

NOTE: For additional operating precautions, please refer

to “Important Safety Instructions” located on Page 2.