Owner's manual
Q: What submap channels do the AV25-2 NET+ use?
A: Since the AV25-2 NET+ is a 2-channel device, only the rst two sub-
map channels are valid (channels 1 and 2). Data sent on channels 3-8
will be ignored.
3.3.2 Using CobraNet Discovery Utility
The CobraNet Discovery utility can be downloaded from the Cirrus Log-
ic website at: http://www.cobranet.info/downloads/disco
Once installed, it should be launched from a computer on the same
network as the AV25-2 NET+. After the program launches it will search
for CobraNet devices. The AV25-2 NET+ will appear as “Attero Tech
CobraNet CEP2224”. If this is the rst time you are setting up this de-
vice, or the device has been power cycled, the IP address will appear
as 0.0.0.0. To set an IP address for easier recognition, right-click the
device and select “Update IP Address”. To ensure visibility, assign it to
the same subnet as the computer you are conguring it from.
3.3.2 Setting Up Bundles
To open up the bundle conguration window, double-click on the de-
vice listed in the screen above. You will see 2 Tx and 2 Rx bundles
ready to congure. Do not congure the two Tx bundles. Single-click on
each of the Rx bundles (shown as 300 and 301 in the screen capture
on the next page) to make the elds editable. From here you can enter
a new bundle numbers.
Rx #1 and Rx #2 directly correspond to Channel 1 and Channel 2 of the
amplier.