Use and Care Manual

ZR380CKT/ ZR380CKB

ASSEMBLY INSTRUCTIONS

P.2/4

DO NOT FULLY TIGHTEN ALL BOLT & HEX NUTS UNTIL THE ENTIRE UNIT IS COMPLETELY ASSEMBLED

Step 2:

Attach the Pull Handle (D) to the Base Cabinet (B) by using Wood Screw (4). Secure well by the screwdriver. Complete by attaching Leveler to

the four corners of the Cabinet (B) bottom.

Step 1:

Attach the Wood dowel (6) to the Base Cabinet (B). After that attach the Table Top (A) to the Base Cabinet (B) by using , Flat Washer (3),

Lock Washer (2) and Bolt (1). Secure well by Allen Key (5). Finally, attach the End Apron (C) to the case then attach Wood Plug (7) to bolt as shown

(Note that the step above are only for the rear two corners.)

Step 3:

Product assembly is now complete.