Use and Care Manual

WS5000
A
SS
EMBLY IN
S
TRU
C
TI
O
N
S
Do
not
f
ully tighten bolts and screws until the entire item is completely assem
bled
P.
2
/
7
STEP 1
Place Table Top (A) upside down on a
non-abrasive surface such as carpet (underside
of table top should be facing up).
4
3
1
DETAIL A
STEP 2
Attach Table Legs (B) to corner of Table Top
(A) with Flat washers (4), Spring washers (3) and
Bolts (1). Finger tighten all bolts until legs are
secure. Do not fully tighten bolts with Open
wrench (2) in this step. (see DETAIL A)
STEP 3
With assistance, carefully turn the table
upright. Ensure the table is level and fully
tighten all Bolts (1) using Open wrench (2).
NOTE: To easy the tightening of the bolts,
fully tighten the bottom bolt first. Finger
tighten the top bolt if it is loose and then
use the Open wrench (2) to fully tighten
the top bolt. Repeat for each leg until all
bolts are fully tightened.
4
3
1
2
4
3
1
A
B
B
B