Use and Care Manual

P.2/4
DO NOT FULLY TIGHTEN ALL HEX NUTS UNTIL THE ENTIRE UNIT IS COMPLETELY ASSEMBLED
Step 3: Place the chair to upright position on flat surface and adjust legs until level and does not
wobble.
Fully tighten all Bolts at this time with Open Wrench (7). Assembly product is completed .
Step 2: Attach the LSF/RSF Front Leg (C/D) to Seat Box w/Seat Cushion (B) by using Flat Washer (5),
Lock
Washer (4) and Medium Bolt (2) secure by Open Wrench (7). Attach the Front/LSF/RSF Side Stretcher
(E/F/G) to LSF/RSF Front Leg (C/D) and Chair Back (A) by securing the Screw (6) with Phillips - head
screw drivers (Not provided).
TF650BCPC / BCTF / BCBK / BCNV / BCRD
ASSEMBLY INSTRUCTIONS
7
2
4
5
A
B
6
6
A
B
D
C
G
F
E
A
B
7
1
4
5
B
7
3
4
5
B
Step 1: Place the Chair
Back (A) on the floor. Attach
Seat Box w/Seat Cushion (B)
to Chair Back (A) by
inserting the Flat Washer (5),
Lock Washer (4), Short Bolt
(3) into the holes at the rear
bar of the seat frame. Insert
Flat Washer (5), Lock
Washer (4), Long Bolt (1)
into the holes at the corner
block of the seat box. Tighten
all Bolt with Open Wrench
(7). Do not fully tighten.