Use and Care Manual

P. 2/4
AK500S
ASSEMBLY INSTRUCTIONS
Do not fully tighten bolts and screws until the entire item is completely assembled.
STEP 1: Place the Chair Back (A) on the floor. Attach Wooden seat (B) to the Chair Back
(A) by using Flat Washer (5), Lock Washer (4), and Long Bolt (3) into the holes at the corner block of the
seat frame. Secure by Allen key (7). Insert Flat Washer (5), Lock Washer (4), Short Bolt (1) into the rear
bar of the seat frame. Secure by Allen key (7). Do not fully tighten.
STEP 2: Attach Left Leg (C) and Right leg (D) to wooden seat (B) by using Flat Washer (5), Lock
Washer (4) and Medium Bolt (2), secure by Allen key (7), attach Left Stretcher (E) and Right
Stretcher (F) by using Screws (6), secure by Screwdrivers. Fully tighten all bolts and screws at this
time. Product assembly is now complete.