Users Manual

steute Technologies GmbH & Co. KG Brückenstraße 91, 32584 Löhne, Germany, www.steute.com
//
RF Tx NGF ULR2.4-safe / RF Rx NGF ULR2.4-safe
6 / 10
Mounting and wiring instructions / Wireless tilting sensor
English
Compliance
This wireless system has been found to comply with several national
and international directives which are listed and explained as follows.
EU: Directive 2014/53/EU (RED)
The wireless system conforms to the European directive on radio
equipment and telecommunications terminal equipment 2014/53/EU.
Protective requirements in regard to electromagnetic compatibility are
carried out under consideration of the harmonised standards
EN 301 489-1/17 and EN 300 328.
Japan: 特定無線設備の技術基準適合証明等に関する規則
(Ordinance concerning Technical Regulations Conformity Certification
etc. of Specified Radio Equipment)
Article 2, Clause 1, Item (19) – 2
Japanese Radio Law and Japanese Telecommunications Business
Law Compliance.
This device is granted pursuant to the Japanese Radio Law (電波法)
and the Japanese Telecommunications Business Law (電気通信事業
法) This device should not be modified (otherwise the granted designa-
tion number will become invalid).
USA: FCC - Title 47 CFR Part 15
Canada: RSS - 247 Issue 2
Notice: Changes or modifications made to this equipment not express-
ly approved by (steute) may void the FCC authorization to operate
this equipment.
This equipment has been tested and found to comply with the limits for
a Class A digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environ-
ment. This equipment generates, uses, and can radiate radio frequen-
cy energy and, if not installed and used in accordance with the instruc-
tion manual, may cause harmful interference to radio communica-
tions. Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user will be required to
correct the interference at his own expense.
This device complies with Part 15 of the FCC Rules and with Industry
Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interfer-
ence that may cause undesired operation.
Le présent appareil est conforme aux la partie 15 des règles de la FCC
et CNR d'Industrie Canada applicables aux appareils radio exempts
de licence.
L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'appareil doit accepter tout brouillage radioélectrique subi, même
si le brouillage est susceptible d'en compromettre
le fonctionnement.