User Guide

SSE 2
Assembly instructions 4-3
4.2. Installing the Dump Valve Sensor
The controller uses a dump valve sensor (A) with a
magnet (B) to determine demand. When the
dump valve is closed, indicating demand, the
magnet is pushed towards the sensor. The
presence of the magnet near the sensor indicates
demand and triggers a new conveying cycle.
When the dump valve is open, indicating that no
material is needed, the magnet is pushed up and
away from the sensor. If the sensor does not
detect the magnet, it does not trigger a new
conveying cycle.
To install the dump valve sensor, insert the
appliance plug of the dump valve sensor into the connector (Figure 3) on the lower side
of the controller.
Figure 3: Lower side of the controller
Figure 2: Dump valve and sensor