Installation Guide

14. Install the Drip Rail
From the inside of the shower with the door panel closed, position the drip rail on the bottom
frame between the strike jamb and the hinge jamb.
Make sure the lip of the drip rail is placed at the bottom of the frame.
Mark the location of the drip rail.
Remove the paper backing from the tape on the drip rail.
Open the door panel and align the drip rail with the location marks on the bottom frame and install
the drip rail.
NOTE: Do not extend the end of the drip rail past the edge of the door panel strike side frame.
15. Caulk the Shower Door
Remove the masking tape from the bottom track.
Carefully apply silicone sealant around the outside of the door where the:
•
bottom track meets the shower ledge.
•
wall jamb meets the wall.
Strike Side
Frame
Inside of
Shower
Bottom Frame
Installed
Drip Rail
Lip installed at
bottom of frame.
Do not extend the
end of drip rail
past edge of strike
side frame.
Caulk here.
Caulk here.
Caulk here.
1034023-2-D 12 Sterling