Specification

Technical Information
Fixture*:
Bathing well:
Basin area,
bottom
50″ (1270 mm) x 25-5/8″ (651 mm)
Basin area, top 59″ (1499 mm) x 33″ (838 mm)
Weight 92 lbs (41.7 kg)
To overflow:
Water depth 15-1/4″ (387 mm)
Capacity 80 gal (352.3 L)
* Approximate measurements for comparison only.
Blower: Heater V Hz A
3-speed 300 W 120 60 9.2
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI):
Blower 120 V, 15 A, 60 Hz
Blower is supplied with a 24″ (610 mm) grounding-type
plug-in cord.
Installation Notes
Install this product according to the installation guide.
Floor support under this product must provide for a minimum
of 41 lbs/square foot (200 kg/square meter) loading.
Blower service access is required.
Size the drain cutout to fit the drain assembly that will be
used.
End stud positioning is critical if nailing-in flanges are to be
used.
Studs should be positioned roughly as shown for support clip
or roofing nail installation.
15"
(381 mm)
27"
(686 mm)
8"
(203 mm)
4"
(102 mm)
40-1/4"
(1022 mm)
14-3/4" (375 mm)
57-3/8" (1457 mm)
28-3/4" (730 mm)
43-3/8" (1102 mm)
11-3/4"
(298 mm)
Ø 2" (51 mm) Drain
Overflow Detail
5-7/8" (149 mm)
3-5/16"
(84 mm)
42"
(1067 mm)
41-1/4"
(1048 mm)
Recommended Support
Clip or Roofing Nail
Location (5 Total)
21"
(533 mm)
72-1/8" (1832 mm) Min
72-1/4" (1835 mm) Max
Ledger Strip Locations
20-5/16"
(516 mm)
Drain Cutout
72"
(1829 mm)
Overflow Detail
5-7/8" (149 mm)
3-5/16"
(84 mm)
Recommended Support
Clip or Roofing Nail
Location (5 Total)
Ledger Strip Locations
Product Diagram
LAWSONTM
LAWSONTM 72″ (1829 mm) x 42″ (1067 mm) DROP-IN AIR MASSAGE BATH
Page2of2
1172620-4-
A