Specification

Technical Information
Fixture*:
Basin area:
Bathing well 44″ (1118 mm) x 25-3/4″ (654 mm)
Top area 51″ (1295 mm) x 32-3/4″ (832 mm)
To overflow:
Water depth 15-1/4″ (387 mm)
Capacity 68 gal (257.4 L)
* Approximate measurements for comparison only.
Pump: V Hz A
1-speed 120 60 7
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI):
Pump 120 V, 15 A, 60 Hz
On models with a heater, a separate dedicated circuit is
required, protected with Class A Ground-Fault
Circuit-Interrupter (GFCI):
Heater 120 V, 15 A, 60 Hz
Installation Notes
Install this product according to the installation guide.
Pump service access is required.
Pump is supplied with a grounding-type plug-in cord for pump
and when included, the heater . Locate the outlet(s) within 24″
(610 mm) of the pump and heater.
Size the drain cutout to fit the drain assembly.
Stud positioning is critical if nailing-in flanges are to be used.
Studs should be positioned roughly as shown for support clip
or roofing nail installation.
60" (1524 mm)
42" (1067 mm)
60" (1524 mm)
20-5/16"
(516 mm)
18-3/4"
(476 mm)
42"
(1067 mm)
27"
(686 mm)
Recommended Support
Clip or Roofing Nail
Location (5 Total)
Ledger Strip Locations
40-1/2"
(1029 mm)
21"
(533 mm)
8-3/4"
(222 mm)
15"
(381 mm)
8"
(203 mm)
4"
(102 mm)
Ø 2" (51 mm) Drain
Drain Cutout
Backing Block
Block Locations (3)
Optional When
Apron is Used
16" (406 mm)
44" (1118 mm)
30" (762 mm)
Overflow Detail
60-1/8" (1527 mm) Min
60-1/4" (1530 mm) Max
3-1/2" (89 mm)
3-5/16"
(84 mm)
Product Diagram
LawsonTM
LawsonTM 42″ (1067 mm) DROP-IN WHIRLPOOL BATH
Page2of2
1105588-4-
C