Installation Guide

Roughing-In
7614 and 7624 Series
IMPORTANT! All dimensions are nominal. The stud opening tolerance is +1/8″ (3 mm)/-0. Carefully
measure your fixture before determining enclosure size. Some shimming between the stud frame and the
fixture may be required. If a firewall is required, rough-in dimensions will have to increase according to
the thickness of the firewall material. Stud opening dimensions must be measured toward the exposed
side of the wall material. Dimensions given in the rough-in information are crucial for proper installation.
Construct the framing and plumbing accurately.
If installing this whirlpool with a shower door, refer to the shower door manufacturer’s instructions for any
special framing considerations.
3-1/8" (7.9 cm)
Overflow Detail
30" (76.2 cm)
14" (35.6 cm)
60-1/4" (153 cm) Min
60-1/8" (152.7 cm) Max
4" (10.2 cm)
16" (40.6 cm)
6" (15.2 cm)
(Typical)
3-1/2"
(8.9 cm)
10"
(25.4 cm)
2" (5.1 cm)
D. Drain
Drain Cutout
1-1/4"
(3.2 cm)
15"
(38.1 cm)
19"
(48.3 cm)
22-1/4"
(56.5 cm)
8"
(20.3 cm)
15-1/4"
(38.7 cm)
8"
(20.3 cm)
55"
(139.7 cm)
73-1/4"
(186.1 cm)
60"
(152.4 cm)
30"
(76.2 cm)
31-1/4"
(79.4 cm)
17"
(43.2 cm)
31-1/4"
(79.4 cm)
Pump Motor
Location
59-3/8"
(150.8 cm)
Sterling 5 1070292-2-E